11/14/2022 0 Comments Bisoncam nb pro settings![]() ![]() ![]() If you’re still using the original wireless card Realtek RTL8187S that came with the Wind, you’ll need Realtek’s wireless drivers for OS X too. The following files have to be copied to the /Extra folder on your USB installation stick and to your Wind’s internal hard drive:ĭSDT.aml – this DSDT needs BIOS revision 1.0E Wind U100 and may not work with earlier/later BIOS revisions or different Wind models! DSDT is patched to fire an event if the lid is closed (important for sleep). You may have to re-apply all the AppleIntel* kexts after an OS X update if your screen resolution falls back to 800×600 mode. Keep the kexts marked red in the /E/E folder on the Wind but remove the grey kexts from /E/E because you just installed them to your /S/L/E folder. I’m always using Kext Helper b7 to do this but OSX86Tools works as well. Once Snow Leopard installation is completed and you installed Chameleon RC3 on your Wind’s internal drive make sure to load the grey kexts (see screenshot, click to enlarge) from /S/L/E. You probably will need a USB mouse and keyboard to complete the OS X installation. If you’re using a USB based installation guide, make sure you put all those kexts in your Chameleon RC3 (or newer) /Extra/Extensions (E/E) folder on your USB stick, even though not all of them may get loaded at that point. This is the list of kernel extensions needed: To run 10.6.1 on the Wind properly there’s quite a number of kexts involved. It may not be neccessary but make sure you enable AHCI disk support in the BIOS (see advanced tab). I suggest you use one of the USB based installation guides to start off with. In fact, Apple already seeded an OS X 10.6.2 developer version with Atom support disabled.Īdded 11/10/09: Do NOT update to 10.6.2 as Apple deliberately disabled Atom CPU support and your MSI Wind netbook will go into a reboot loop or simply crash! You’ll need a modified kernel to run 10.6.2 or higher on an Atom CPU! If you’re fluent with Terminal, you might as well install the 10.6.2 update and reinstall the old kernel, see this post for more information. There are rumors that this may change in a later release of OS X. Even though I haven’t personally tested it, the kexts should also work in the Wind U100 plus model. Up to OS X 10.6.1 the Atom 270/280 CPUs are natively supported by the Darwin kernel a.k.a. This is not a how-to guide, tutorial or walk-through, I just list the kexts and settings needed to get Snow Leopard 10.6.0 or 10.6.1 up and running on an MSI Wind U100 netbook. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |